|
 |
 |
|
(TP) THREAD POINT
TP (Thread Point) Fastener
If you're looking for a cost effective fastener for fastening into wood or light
to medium gauge steel decks, the TP (Thread Point) Fastener will meet your needs.
The TP (Thread Point) Fastener has a sharp rolled point in combination with twin lead threads which allow fast accurate penetration into both wood and steel decks.
|
|
|
|
 |
Head: #3 deep recess Phillips drive provides positive driving. |
| Threads: 11 twin lead threads per inch. Twin lead threads are two complete sets of threads, one opposite the other. This provides faster drilling, and perpendicular entry into the deck. | |
| Corrosion Protection: TRU-KOTE™ PC-3 coating meets or exceeds FM4470 corrosion standards and withstands 30 cycles of the Kesternich DIN 50018 SFW 2.0 test. | |
| Back-out Resistance - tapered wedge entry: The sharp rolled (Gimlet) point combined with twin lead threads penetrate steel or wood decks actually pulling and forcing the fasteners entry, wedging it tightly to provide back-out resistance. RESULTS! No costly call backs. | |
| Thread Point: A sharp rolled (Gimlet) point to drill wood or 20 ga. - 22 ga. steel. |
| STEEL | WOOD | Note:
All tests were conducted by an independent testing laboratory. Results
of these tests are offered only as a guide and are not guaranteed in any
way by TRUFAST
CORPORATION.
Designated holding values depend on the quality
of materials being anchored to. TRUFAST
CORPORATION
recommends that pull-out tests be conducted to verify that the substrate
provides adequate pull-out values. |
| Pull-out Values | Pull-out Values | |
| 20
Ga. - 560 lbs. 22 Ga. - 410 lbs. 24 Ga. - 364 lbs. |
1/2"
Plywood - 348 lbs. 3/4" Plywood - 585 lbs. Plank 1" Embedment - 353 lbs. |
| © Copyright 2006 - Trufast, LLC |
